The Lee Classic Cast 50 BMG Press Kit reloads the monster 50 BMG. The frame is made of rigid cast iron and has a large frame opening for hand clearance. This Press also has a Large diameter ram 1 1/8". Hose fitting allows primer disposal directly to the trash can and has a automatic primer arm with bottom of stroke priming.

The Lee Classic Cast 50 BMG Press Kit is an affordable way to reload the monster 50 BMG. The frame is made of rigid cast iron and has the largest frame opening for unlimited hand clearance. This Press also has the Largest diameter ram 1 1/8". Hose fitting allows primer disposal directly to the trash can. For the best feel, The press has a automatic primer arm with bottom of stroke priming.

Cast & Machined with PRIDE in the USA

INCLUDES:

• Lee Precision Classic Cast Press
• Lee Precision 2 Die set for 50 BMG
• Lee Precision 50 BMG Shell Holder
• Lee Precision 50 BMG Ram Prime tool
• One tube of Lee Precision Case Sizing Lube
• Lee Precision Shell Holder Insert
• Lee Precision Large Primer Arm
• Lee Precision Small Primer Arm
• Lee Die Reducer Bushing to accept standard 7/8-14 dies

Note:

• These additional components (above) allow you to load all your smaller cartridges with the same press making this a truly versatile set up. And all for less than others charge for dies alone.
• For Instructions and more Information, click the "Man" Icon.

IT IS YOUR RESPONSIBILITY TO ENSURE THE SAFETY OF YOUR LOADS

FACTORS THAT WILL INCREASE PRESSURES. SOME WILL BE DANGEROUS:

• DO NOT USE more powder than recommended
• DO NOT USE a heavier bullet than recommended
• DO NOT SEAT the bullet deeper than normal
• DO NOT USE magnum primers unless using a slow burning ball powder
• Greatly oversize bullets, excessively hard bullets or cases that are too long will cause higher pressures
• High temperatures or cartridges that were stored in a hot car or trunk will produce higher pressures